Not Recommended for New Designs / End of Life - Please see First Page
+In / -In DC Voltage Ports
MV036 SERIES
The VTM ? input should be connected to the PRM ? output terminals.
4
3
2
1
Given that both the PRM and VTM have high switching frequencies, it
is often good practice to use a series inductor to limit high frequency
currents between the PRM output and VTM input capacitors. The input
voltage should not exceed the maximum specified. If the input voltage
exceeds the overvoltage turn-off, the VTM will shutdown. The VTM
does not have internal input reverse polarity protection. Adding a
properly sized diode in series with the positive input or a fused reverse-
shunt diode will provide reverse polarity protection.
+Out
-Out
+Out
A
B
C
D
E
F
G
H
J
K
L
A
B
C
D
E
H
J
K
L
+In
TM
VC
PC
M
M
TM – For Factory Use Only
-Out
N
P
R
T
N
P
R
T
-In
VC – VTM Control
The VC port is multiplexed. It receives the initial V CC voltage from an
upstream PRM, synchronizing the output rise of the VTM with the
output rise of the PRM. Additionally, the VC port provides feedback to
Bottom View
the PRM to compensate for the VTM output resistance. In typical
applications using VTMs powered from PRMs, the PRM’s VC port
should be connected to the VTM VC port.
The VC port is not intended to be used to supply V CC voltage to the
VTM for extended periods of time. If VC is being supplied from a source
other than the PRM, the voltage should be removed after 20 ms.
PC – Primary Control
The Primary Control (PC) port is a multifunction port for controlling the
VTM as follows:
Disable – If PC is left floating, the VTM output is enabled. To
disable the output, the PC port must be pulled lower than 2.4 V,
referenced to -In. Optocouplers, open collector transistors or relays
can be used to control the PC port. Once disabled, 14 V must be
re-applied to the VC port to restart the VTM.
Primary Auxiliary Supply – The PC port can source up to 2.4 mA
at 5 Vdc.
+Out / -Out DC Voltage Output Ports
The output and output return are through two sets of contact
locations. The respective +Out and –Out groups must be connected in
parallel with as low an interconnect resistance as possible.
To take full advantage of the VTM, the user should note the low output
impedance of the device. The low output impedance provides fast
transient response without the need for bulk POL capacitance. Limited-
life electrolytic capacitors required with conventional converters can be
reduced or even eliminated, saving cost and valuable board real estate.
Signal Name
+In
–In
TM
VC
PC
+Out
–Out
Figure 9 — VTM pin configuration
Pin Designation
A1-E1, A2-E2
L1-T1, L2-T2
H1, H2
J1, J2
K1, K2
A3-D3, A4-D4,
J3-M3, J4-M4
E3-H3, E4-H4,
N3-T3, N4-T4
MIL-COTS Chip Transformer
Page 6 of 10
Rev 2.9
01/2014
vicorpower.com
800 927.9474
相关PDF资料
MZ1608-202Y BEAD FERRITE 2000 OHM 1608
NBL-621/DN BATTERY LITH COIN 2V RECHARGE
NCS6D1212C CONVERT DC/DC +/-12V 250MA THRU
NDH2415SC CONV DC/DC 3W 24VIN 15VOUT SIP
NDL2409SC CONV DC/DC 2W 24VIN 9VOUT SIP
NDS03ZE-M6 CONV DC-DC 48V IN 3.3V OUT 10W
NDS6D2415C CONVERT DC/DC 6W 24-15V DUAL T/H
NDTD4815C CONV DC/DC 3W 48VIN 15VOUT DIP24
相关代理商/技术参数
MV-040040-25-8A 制造商:TE Connectivity 功能描述:Labels Thermal Transfer Printable Label Polyester Matte Silver 4x4mm
MV04TFNSW-RA000-D 制造商:Delkin Devices 功能描述:USB EMBEDDED 4GB - Bulk
MV055F1CAX10E 功能描述:保险丝 5500V 10A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485
MV055F1CAX15E 功能描述:保险丝 5500V 15A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485
MV055F1CAX20E 功能描述:保险丝 5500V 20A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485
MV055F1CAX25E 功能描述:保险丝 5500V 25A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485
MV055F1CAX30E 功能描述:保险丝 5500V 30A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485
MV055F1CAX40E 功能描述:保险丝 5500V 40A For Transfrmr and Feedr RoHS:否 制造商:Littelfuse 产品:Surface Mount Fuses 电流额定值:0.5 A 电压额定值:600 V 保险丝类型:Fast Acting 保险丝大小/组:Nano 尺寸:12.1 mm L x 4.5 mm W 安装风格: 端接类型:SMD/SMT 系列:485